This product is no longer available and has been replaced by: CS456-L. Some accessories, replacement parts, or services may still be available.
| Services Available | |
|---|---|
| Repair | No |
| Calibration | No |
| Free Support | No |
Overview
The CS420 was manufactured by Druck for use in surface, groundwater, or hostile fluid applications. It was quite similar to the CS425 (retired also), but offered increased static accuracy. The sensor's accuracy was ±0.1% FS, BSL (combined non-linearity, hysteresis, and repeatability). The CS420 featured a titanium body with an isolated diaphragm and NEMA6 (IP68) ingress protection to 2300 feet of water.
Read MoreImages
Technical Description
The CS420 was removed from our pricing system on December 5, 2008.
Specifications
- Weight: 3 lbs
- Length: 4.0" (10.2 cm)
- Diameter: 0.8" (2.0 cm)
- Output voltage: 25 mV for 1 psig range, 50 mV for 2.5 and 5 psig ranges, 100 mV for ranges 10 psig and above
- Operating Temperature Range: -2° to +30°C (compensated)
Compatibility
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Dataloggers
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR1000 (retired) | ||
| CR10X (retired) | ||
| CR200X (retired) | ||
| CR211X (retired) | ||
| CR216X (retired) | ||
| CR23X (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR800 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR850 (retired) | ||
| CR850 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | ||
| CR9000X (retired) |
Additional Compatibility Information
Data Logger Considerations
Excitation voltage from the data logger and either one (four-wire gages) or two (six-wire gages) differential channels are required. Four wires can be used where cable lengths are short; six wires compensate for excitation voltage loss on long cables, thereby improving accuracy.
PST System
The CS420 is NOT compatible with the PST system. [Underwater connectors for vented transducers are available. Contact Druck for pricing and details.]
Related Documents
Product Brochures
Related FAQs
Number of FAQs related to CS420-L: 2
-
The information included on a calibration sheet differs with each sensor. For some sensors, the sheet contains coefficients necessary to program a datalogger. For other sensors, the calibration sheet is a pass/fail report.
-
This depends on the information contained in the calibration sheet:
- If the calibration sheet contains coefficient information, Campbell Scientific keeps a copy, and a replacement copy can be requested.
- If the calibration sheet does not contain coefficients, Campbell Scientific does not keep a copy. It may be possible to contact the original manufacturer for a replacement copy.