Resistive bridge adapters provide the completion resistors necessary for half-bridge measurements, help measure platinum resistive thermometers (PRTs), and are used with strain gages or other sensors that act as a single variable resistor.
The 4WFBS120 is a 4-wire, full-bridge module that provides completion resistors for a strain gage or other sensor that acts as a single variable resistor. This module should be used to measure sensors...read more
The 4WFBS350 is a 4-wire, full-bridge module that provides completion resistors for a strain gage or other sensor that acts as a single variable resistor. This module should be used to measure sensors...read more
The 3WHB10K provides the completion resistor required for a 3-wire half-bridge measurement. It is typically used with 100 Ω and 1000 Ω platinum resistive thermometers (PRTs).read more
The 4WHB10K provides the completion resistor required for 4-wire half-bridge measurements. This module should be used with sensors that have a 10 kΩ resistance.read more
The 4WFBS1K is a 4-wire, full-bridge module that provides completion resistors for a strain gage or other sensor that acts as a single variable resistor. This module should be used to measure sensor...read more
The 4WPB500 provides completion resistors to enable your Campbell Scientific data logger to measure 500-ohm platinum resistive thermometers (PRT) using the half-bridge four-wire measurement method.read more
This website uses cookies in order to offer you the most relevant information. Please accept cookies for optimal performance.
Cookies expire 30 days from acceptance.
Please note that we also leverage third-party tools, such as Google Analytics, which may use cookies to collect information about your browsing activities. We cannot block these cookies, but we ensure that any third-party tools we use are GDPR-compliant and do not collect any personally identifiable information.