Water Level, Stage & Flow Sensors / CS440-L
| Services Available | |
|---|---|
| Repair | No |
| Calibration | No |
| Free Support | No |
Overview
The CS440 submersible pressure transducer output a 4-20 mA signal to indicate observed pressure level. The CURS100 was typically used to convert the 4-20 mA signal to a millivolt signal. The data logger then converted the millivolt signal to user-selected units (such as psi or feet). The static accuracy was ±0.1% over a 0° to 50°C temperature range.
Read MoreImages
Technical Description
The CS440 was removed from our pricing system on August 22, 2008.
Specifications
- Excitation: 8 to 24 Vdc
- Static Accuracy: 0.1% span BFSL
- Operating Temperature: 0° to 60°C, nonfreezing
- Diameter: 1.0" (2.5 cm)
- Length: 13" (33.0 cm)
- Cable Diameter: 0.29" (0.74 cm)
Compatibility
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Dataloggers
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR1000 (retired) | ||
| CR10X (retired) | ||
| CR200 (retired) | ||
| CR23X (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR850 (retired) | ||
| CR850 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | ||
| CR9000X (retired) |
Additional Compatibility Information
Data Logger Considerations
The CS440 is measured with a single-ended data logger instruction after converting the sensor signal from milliamps to millivolts using a 100 Ohm resistor.