The CR1000KD is a portable keyboard and display screen for our CR1000, CR800, and CR6 dataloggers. It allows you to check the datalogger's status, display or plot sensor readings and stored values, an...read more
The CD100 is a mountable display with a keypad for data logger data entry and display. It has a vacuum fluorescent display for responsive use through a very wide operating temperature range. Its opera...read more
The SC32B Optically Isolated Interface is used to connect the CS I/O port on a datalogger with the RS-232 port on a PC. This interface converts the RS-232 voltage levels of the computer to the CMOS le...read more
The SC115 is a lightweight, portable, 2 GB device that allows you to augment your onsite data storage or to transport data between the datalogger and PC. It is used with our newer dataloggers, and it...read more
The SC-CPI is an interface between the serial port of later-model Campbell Scientific dataloggers (CR800/850, CR1000, and CR3000) and our new Campbell distributed modules (CDMs). The CDMs use the new...read more
The SC110 consists of two cables to connect a data logger with RS-232 DCE and DTE devices. One end of each cable provides stripped, tinned leads for attachment to the control ports on a CR800, CR850,...read more
The 21852 is offered for customers who order a new data logger and, in addition to the Campbell Scientific calibration over the selected temperature range, require calibration verification from a cert...read more