Projekt 2:
We have a Station equipped with Datataker-Logger DT85 AND TDR100 AND one SDMX50, Operating time 20 Years.
On the SDMX are 8 Sensors Type CS605 with RG58-cable and fixed lenth of 5 meters
The SDMX50 are connected with RG58 cables:
TDR -> 3,6m -> SDMX50
The maximum cable-length is 8.6 meter
The DT85 is connected over the serial-connection to the TDR100. With the DT85 I can send and receive serial commands.
Up to now it's possible to address a Mux and read out the moisture with the command "GMO" - get moisture.
BUT! - The Output is now always around zero, even when a sensor is underwater.
My questions are now:
1: How do I have to preset the TDR100 EXACTLY to get proper values?
2: What accuracy has the result?
3: Is it possible to store the sensorspecific data for each sensor into the TDR100?
4: How can I store one configuration to the TDR100 that fits for all Sensors?
Thank you for any help
You may want to pose your questions to a DataTaker support forum, or to DataTaker directly.
Regards,
Dana W.