We recieved a new datalogger (CR1000) and connected to the laptop with CS-USB cable. Using LoggerNet, I set up it but the test communication failed. I included the Baude no., pakbus no. as mentioned in the manual and at the correct serial port. still its not respoinding.
Please let me how to fix it.
chamindu
I guess the SC-USB drivers installed OK and you have matched the com port number assigned to the SC-USB during the installation to the one you are using in Loggernet?
One other simple check, apart from logger power etc, is that you have plugged the SC-USB into the CS I/O connector not the RS232 connector. They are the same gender so this is an easy mistake to make (done it myself!)