Good Day
I have about 16 10HS Moisture Sensors connected to a CR1000. The logger is supplied by a 12V battery and as you know batteries are not a constant supply.
My question is: Will the change in battery voltage effect the moisture readings that I get from my 10HS Sensors as I have noticed a considerable change in mV of the sensors as the battery voltage depreciates.
Another question: Will the lenght of the cable effect the sensor readings.. They are normally around 5m when you purchase them, what would happen if i extend the cable to 10 m.
I have it connected Single Ended:
Red to SE Channel
White to SW12
Screen to ground.
Thanks