I am trying to connect to my CR206X datalogger using Loggernet. When I first open Loggernet and try to connect, I get 2 error messages. "transaction failure','unreachable destination',"Get Logger Program Status'" and "transaction failure','unreachable destination','check/set clock". I can go through the EZ Setup process and "Test Connection", and the connection always works properly, then I am able to connect and disconnect the datalogger withought problems. The only time I have problems and get error messages is on the first connection after opening Loggernet. Any suggestions? Thanks, Rick
its a bit too early to know exactly what the problem is, but when i'm troubleshooting the first place i go when i don't connect is to the device configuration utility that comes with loggernet.
open that up with loggernet closed,
choose the CR200 series logger from the list on the left of the screen.
make sure your port is properly selected and hit connect.
this will eliminate any loggernet errors you might have in your software. other than that we're down to troubleshooting power issues and what not.
email me and i'll go over it with you if you like
mike
mlusk@inmtn.com
www.inmtn.com
Hi, I experience a kind of similar problem. I have 6 CR200 stations. 5 working fine but one encounter problems like discribed above. Anyone that can help me?
Thijs
You will need to provide more information about your network, your setup, etc. The message basically indicates that LoggerNet can not reach the CR200. This can happen for numerous reasons, especially when we don't know anything about your setup.
Hi Sam,
I'm using a TAPI modem (landline) to call the station (GPRS modem TX009), loggernet V4.1.0.16. Setup for calling: BR 9600,
PB 1,extra respons time 10s.
Is this what you need, or do you need additional information?
For good understanding, I'm not an advanced user. So if you can, specify more the information you need.