Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

DTS-12 Turbidity Sensor with CRBasic

sbuettner Jul 12, 2010 05:11 PM

I am wondering if anyone can help me out with programming a DTS-12 SDI Turbidity Sensor. I need to figure out how to communicate with it through a Campbell logger CR1000. I have data connected to C1 with ground wire and 12v wire connected to the correct places. Could anyone give me the steps I need to send the SDI commands to the sensor? Thanks

IslandMan Jul 13, 2010 10:27 AM

Short Cut, which is included with Loggernet, has programming guidance for SDI-12 sensors. Suggest you start developing your program in there. Between ShortCut and the sensor manual it should be easy to sort out.
IslandMan

Log in or register to post/reply in the forum.