Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CC640 digital camera

julio Mar 2, 2010 01:06 PM

I am looking for the CR Basic program in CR1000 to connect the CC640 digital camera!.
I have a DB9M-terminal to wired in RS232 conecction!. I want to connect the digital camera in this mode (RS232).

thank you.

Sam Mar 14, 2010 08:22 PM

Julio,

Please see the CC640 manual at http://www.campbellsci.com/documents/manuals/cc640.pdf and the CR1000 manual at http://www.campbellsci.com/documents/manuals/cr1000.pdf.

A very common operation mode is to have the camera push images to the logger on a time interval, and the CC640 manual shows how to do this with Device Configuration Utility. Also See section 13.5 for configuring the RS232 port of the CR1000. When using this "push" type of operation mode, no special CRBasic programming is needed - only Device Configuration settings.

Log in or register to post/reply in the forum.