Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

read values from CR1000 over tcp/ip

hamshari Aug 23, 2016 03:31 PM

CR1000 is connected to pc through ethernet and monitoring all variables by CP400 monitoring software ok, can we in addition connect to CR1000 from master PLC using modbus tcp/ip to read data? and how.

JDavis Aug 23, 2016 03:39 PM

The CR1000 can simultaneously communicate over Modbus TCP.

Modbus Master and Modbus Slave can be found in the Control grouping during sensor selection in the ShortCut program generator.

Log in or register to post/reply in the forum.