Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Setting offset, slope, email CR1000

dennisb Jan 2, 2016 09:05 PM

Hi,

How do I input the data from calibration certificates (Thies sensors) on a CR1000? My programming skills are below par.

Thank you.

JDavis Jan 11, 2016 08:58 PM

It would be helpful to specify which models of Thies sensors you have.

The sensors can most likely be measured utilizing the generic measurements in Shortcut. All of the generic measurements allow inputing a multiplier and offset for your sensor.

Log in or register to post/reply in the forum.