Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Output voltage for heat flux plates

aoliveira Sep 17, 2015 03:05 AM

Hi,

I am working in a CR1000 program that will include two HFT3.1 flux plates from REBS and other two HFP01 plates from Hukseflux. Is it ok to use 2.5 mV and 25 mV, respectively, as voltage output range for these sensors?
BTW, does anyone have a CR1000 program with these plates that could share?
I appreciate any help!

Thanks!

JDavis Sep 17, 2015 05:01 PM

There is an example program for the CR3000 in the HFP01 manual. For the CR1000, you would use the mv250 range.
https://www.campbellsci.com/hfp01

The HFT3 manual won't be updated for CRBasic dataloggers. The measurement is just a VoltDiff. Use the mV7.5 range.
https://www.campbellsci.com/hft3-l

Log in or register to post/reply in the forum.