Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Connecting CR800 with GMS Modem - Siemens TC35i Engine

MCTT Sep 11, 2009 07:24 AM

Dear All,

we would like to integrate CR800 with GSM Modem - Siemens TC35i engine using AT Command.

if you have any documents about this connecting please send it to me.

Thanks very much.

Best Regards,
Nguyen Van Hung

aps Sep 11, 2009 09:35 AM

Is this for GSM dial-up or GPRS connectivity.

For general GSM dial-up use you can follow the instructions for the TC35T modem. For GPRS we have had users follow the info in the CS-GPRS manual successfully using Siemens modems. There are are only a few changes necessary, such as the connect message. We cannot offer formal support on this though.

Those manuals can be found here:

http://www.campbellsci.co.uk/index.cfm?id=327

Log in or register to post/reply in the forum.