Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

information about cs100 or cs106

fdec Sep 26, 2014 06:47 AM

Dear All

i need to realese a pressure measure with a cs100 or a cs106.

i will not use a cr1000 as i already use but that will be wired on an automate and i ask about the control port.

what is the control port? i have none on the automate?

can you enlighten me?

regards

smile Sep 26, 2014 05:00 PM

Hi fdec

You can use a voltage to 5Vdc TTL, is an input that controls the ON/OFF state of the sensor, These measures often making very slow and it can be held off for a long time to save energy.

Regards

Smile

Log in or register to post/reply in the forum.