Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Handar CR3000 program

AMK Aug 21, 2014 06:32 PM

Hello Forum,
I'm looking for a full 2D Vaisala WS425 program for CRBasic. We have a working version but it only uses the windvector program call and does not output Ux or Uy. Any information on this would be very much appreciated.

Thanks!
AMK

smile Aug 29, 2014 02:35 PM

Hi

which type of output do you have? RS232, SDI-12 analog?

Smile

Log in or register to post/reply in the forum.