dear all
happy new year
i have a gprs modem fasttrack ans i have lost the connection with it.
For discover where is the problem,
I'd like to see if the modem has retained its initial programming parameters.
does it's possible?
while waiting to read you
regards
I guess you have gone to site and can connect the modem to a PC to check it out. If so you can try the AT&V command which will show you a subset of the settings. Most other settings can be compared to the recommended settings by adding "=?" to the command and checking the response. Compare these to the CS manual supplied with the modem package.
Dear APS
i have try the command AT&V on the fasttrack modem.
plese find the return below :
AT&VQ:0 V:0 S0:001 S2:043 S3:013 S4:010 S5:008
+CR:0 +CRC:0 +CMEE:0 +CSBT:0,0,1
+SPEAKER:1 +ECHO :0 &C:1 &D:2 %C:0
+IPR:115200 +ICF:3,4 +IFC:0,0
0
so i have try to add the command =? and the answer are 4
can you explain to me what does this answer mean?
regards
The "4" indicates an error in the command you typed.
There are some commands that are not reported by the AT&V0 command (the output of which looks OK to me). What I was trying to tell you to do was to work through each command listed in the setup of our manual, relevant to the Fasttrack, and check the setting, e.g.
AT+IPR=?
(Although in that case you can see the setting, which is 115200 baud, in the output of the AT&V comand).