I brought my data logger from the field into the office to do some troubleshooting...not of the data logger itself. At that time I could communicate with the data logger using my computer over the SC-USB cable. While the setup was in my office I inadvertantly drained the battery (forgot to shut it off). The battery has since been charged and I can see the AVW200 gets power, but the light doesn't flash on the data logger, but I do get power to the Power In connection. I cannot ping or connect to the data logger using the comm test in the troubleshooter or in the device configuration utility. I know the com port setting is correct. I have set the PakBus Address on the datalogger to both 200 (which worked in the past) and to 1. The PakBus Address on the PC us 4094. Any ideas on what to check next?