Hi to all,
I am very new to the CR Basic, so i hope someone can help me out.
We have the following application, 2 CR1000 datalogger has to send some variables to 1 master CR1000 datalogger.
The data that has to be send (all throu GPRS) are some variables from data tables.
In this configuration CR1000 is passive cause it has only receive data.
On the master cr1000 we have connected SDM-CV04 unit.
The SDM-CV04 unit has to convert to variables into 4-20mA signal (for the end user)
Basically my questions are;
1. Can someone provide a cr1000 program on how to send and receive data throu GPRS?
2. Can someone provide a cr1000 program on how to program the SDM-CV04? (with excample voltage or panel temp variable)
Ps: we issue GPRS modems (type 110) with dynamic Ip adress witch we will provide a hostname throu DYndns.
I hope someone can help me.
Thank you
Hi,
as for point 1 i meant the sending and receiving data between two cr 1000 loggers.
Regards,