Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

ETsz Units in Output

LarryT Aug 25, 2013 09:21 PM

When I use the ETsz output instruction, the units listed for the two data points are listed as "degrees". Is there anyway to change the units of Fieldnames? I know the two output values are millimeters for ETso and MJ/m2 for Rso but that is not what shows up in the output table.

Thanks,

Larry

Dana Aug 26, 2013 06:09 PM

Use the FieldNames instruction after the output instruction in the data table.

This post discusses the instructions's use:

http://www.campbellsci.com/forum/messages.cfm?threadid=3145B5FC-855E-4715-98FF37F6752EDC1C

Dana W.

LarryT Aug 30, 2013 12:01 AM

Thanks Dana but I know how to use Fieldnames, that's not the issue. The problem is the UNITS assosiated with these fieldnames in the output data. In this instance, the ETsz instruction assigns the units as 'Degrees C' when they should be millimeters and MJ/m2. I can put the units in the fieldname but would like to be able to put the correct units in the data output as well. Can you set the units using an "Units=" for fieldnames?

Thanks,

Larry

Log in or register to post/reply in the forum.