Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Optical Probes to CR1000

JMD78 Aug 14, 2013 05:46 PM

Hello,

Does anyone have experience and/or code they would share for using optical probes with Campbell Sci data loggers? Specifically I will be using Turner Cyclops 7 probes. I plan to power three through the SW-12 V. It should be pretty simple, however I am new to these probes and would love to hear other peoples experience and tips.

Thanks,
Joseph

jeff Aug 20, 2013 04:20 PM

Try using the VoltDiff instruction. The signal wire will go to the high side of the differential channel, and the signal reference to the low side. The output signal from the sensor is 0-5V. You can use autorange in the range parameter of the instruction to get better resolution.

Petser Dec 15, 2014 02:26 PM

Hi

I would like to know if any knows what the wiring diagram of the Turner Cyclops 7 in vivo Chlorophyll and Turbidity is and the script for its functionality.

Regards

Sergio

Log in or register to post/reply in the forum.