Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR10KD

mewindy2 Oct 12, 2024 01:34 AM

Hi

is it possible to display the current windspeed on a CR10KD display that is connected to a CR10WP data logger

(i.e what is the key board sequence)

thanks!

Brian

mewindy2 Oct 12, 2024 09:40 PM

ok,figured it out'

just go *6

then A , then A then A again to advance through to the windspeed value for the program that i had loaded (using short cut)

i.e just scroll though the values in the table for the loaded program

easy

* Last updated by: mewindy2 on 10/12/24 @ 9:42 PM *
smile Oct 16, 2024 04:44 AM

Hi

for complete set of command, read the logger manuals CR10, CR10X CR510, it's all explained

this is the link

https://www.campbellsci.co.uk/manuals

smile

Log in or register to post/reply in the forum.