Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR1000 direct connect issues


Paul Heinrich Oct 30, 2023 03:08 PM

I'm having difficulty connect to some of my CR1000 dataloggers using PC400 4.7.  I'm using a serial cable plugged into the RS232 port.  These dataloggers also have NL116 interfaces and some are being polled over cell.  When I try to connect the device times out, but if I change the baud rate, it will immediately connect and then function normally.  They also seem to connect just fine using the Device Configuration Utility. 

Log in or register to post/reply in the forum.