Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

set port high in CR1000

Arvin Jun 15, 2009 09:47 PM

hello,

can any body tell me how I can set a port (you say port 1) high?

and how I can have the CRBasic syntax manual.


thanks,

IslandMan Jun 16, 2009 10:55 AM

Arvin,

To set Port 1 high:
PortSet (1 ,1 )
To set Port 1 low:
PortSet (1 ,0 )

Dave

Log in or register to post/reply in the forum.