Hi,
I am writing a table file wihtin my scan procedure. In firm ware version 24 of the CR1000/CR800 I noticed that the names are not written properly:
The names are defined as e.g. RDX(1), RDX(2), RDX(3) and so on. If I collect the data through loggernet the TOA5 file looks o.k. If i do so through the table file function and open the file the names are partly cut like RDX (the (1) is missing).
On one logger where I still run firm ware version 14 none of the numbers are written, i.e. the header looks like RDX, RDX, RDX...
Any help is appreciated
cheers
Hans