Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

HMP35C sensor

Kenny Aug 13, 2012 07:13 PM

I have some HMP35C sensors that the ends have been cut off, the part that Campbell Scientific added. I have the components to replace them with, except I don't have a schematic showing the layout of the components. Would anyone have a schematic for this?

Any help will be appreciated.

Regards,

Ken

Log in or register to post/reply in the forum.