Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR1000 via RF416 communicate w/ LabView

chliao May 15, 2009 06:02 PM

Dear Campbell Develop Engineer,

My system is a AM25T multiplexer connected to a CR1000. The CR1000 is wirelessly communicated to my PC via RF416 transmitters (serial port converted to usb port). I would like to integrate the system into a LabView program. Have anyone done this before? Or does Campbell have a existing vi to support this system? Thank you very much.

Resagrds,
HS

Dana May 18, 2009 07:51 PM

There is a plug-in that works with LoggerNet's TOAC1 and TOA5 *.dat files:

http://zone.ni.com/devzone/cda/epd/p/id/5720

Hope this helps,

Dana

Log in or register to post/reply in the forum.