Is it possible to sync the time between two CR1000 data loggers?
I can't connect a computer with LoggerNet. At the site i have not enough power.
Both loggers measure high frequently and the time on each logger should be exactly the same.
Greetings
Uwe (Germany)
With the dataloggers connected together over some form of serial/pakbus link you can sync one to the other using the Clockreport and PakbusClock instructions in the loggers (See the CRBasic help).
IF the connection is over IP, then you can use the NetworkTimeProtocol instruction where one logger acts as a time server, as outlined in another thread recently.
Thank you very much!
These instructions i had overlooked. I try out it immediately.