Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Stevens Probe SDI12, programming

Leonardo Apr 22, 2009 01:38 PM

Hi,

I am trying to program several Stevens SDI12 Hydra probes (Standard). I have achieved to communicate with the sensor and have some measurements. The sensor is connected to 12VC power out and the C1 I/O port, with the following code...

SDI12Recorder(Results(),1,"2","M!",1,0)


Is there a need to program warming up, measurements and communication times? Should I use the 12switch instead of the 12VC? Should I use the HydraProbe CRBASIC command even if I have SDI12 and not VoltDiff?

Thanks,

Log in or register to post/reply in the forum.