FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1922 total: showing 1841-1860)

How can the 229-L be calibrated?
How are readings obtained from the 229-L?
Is calibration of the 229-L available?
If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
To use a multiplexer with a CR10X and very low sensor signals (1 mV and lower), should an AM25T or an AM16/32 be used? For which sensor signal voltages and sensor impedances can the AM25T and the AM16/32 be used?
How should the AM25T be used?
Can the AM25T be connected to an analog input channel on a device other than a datalogger, such as a programmable logic controller (PLC)?
What is the measurement resolution, in Hertz, of the AVW1, AVW4, or AVW100? Do these interfaces have any certifications of compliance?
Does the AVW100 work with Edlog Instruction 28 or 131?
How can the datalogger build a text string and send it out the RS-232 port?
What is needed to write a simple program that will read two analog channels (0 to 10 Vdc)?
When dialing up the 21X, the barometric pressure data is displayed in real time. When the data is collected via either dial-up or a storage module, the barometric data are all zeros. Why does this happen?
Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a datalogger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?
Does Baler 2.2 work with a CR800? Is a more recent version of Baler needed?
In what format does the Baler Client Software save the data? Are there format options?
Is there a patch for the current version of Baler?
When trying to start LoggerNet, what might cause the "Unable to start program because the Campbell Scientific communications server is already running" message?
After installing an upgrade to the current version of LoggerNet, why does the Toolbar no longer show all the buttons?
Does PConnectCE work with Windows Mobile 5.0?
Why is the battery in the BP12 and BP24 assembly taller than the bracket?

Previous Next