FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1922 total: showing 101-120)

What are the multiplier and offset values used with the BaroVue™10?
If the BaroVue™10 is not available for selection in the Short Cut program, how can it be added?
Can the BaroVue™10 be used to measure pressure in an application at very high humidity without damaging the sensor?
How often should the BaroVue™10 be factory calibrated?
What is the warm-up time for the BaroVue™10?
Is the BaroVue™10 a direct replacement for the CS106 and CS100?
Does the BaroVue™10 need to be vented to the outside of an enclosure or building?
Does the BaroVue™10 fit inside an ENC100 enclosure?
What are the features and benefits of the BaroVue™10?
Why are sites needed for a Wintersense network?
Does the mast of the CM375 have any lightning protection?
If duckbill anchors cannot be used to stabilize the CM375 in uneven, rocky terrain, what should be used instead?
Can the base plate of the CM375 be fixed to the ground to improve stability, especially in rocky, mountainous areas?
Can the mast and the guy cables of the CM375 support ice loading?
Under what temperature conditions can the CM375 operate?
What is the probable life expectancy of the CM375 mast?
Is the CS241 recommended for use at the back or the front of the bifacial module?
For the standard (non-NIST) version of the CS240 sensors, how does Campbell Scientific verify the ability of the sensors to measure and that the measurements made are calibrated to provide correct measurements?
What are the differences between the different turbidity units used, such as NTU, FBU, FTU, and FNU?
What is the difference between the backscatter measurement of the OBS-3+ and the side-scatter measurement of the ClariVue™10 sensor?

Previous Next